Global Accelerator
Global Accelerator
- What's New
- Service Overview
- Getting Started
- User Guide
-
FAQs
- Can I Use the Ping Command to Test Latency?
- How Will I Be Billed for Global Accelerator?
- How Can I Increase the Global Accelerator Quotas?
- How Can I Use Traffic Dial to Distribute Traffic?
- What Types of Endpoints Can Be Added to a Global Accelerator?
- Can I Use Global Accelerator in an Area That Is Not Listed Among the Acceleration Areas?
- What Are the Statuses and Health Check Results of Endpoints?
- What Should I Do If an Endpoint Is Unhealthy?
- Most Frequently Asked Questions
- Configuring the TOA Module
- How Can I Use Global Accelerator to Enable European Users to Access the Applications Deployed in or Outside the Chinese Mainland (Excluding Europe) Faster?
On this page
Show all
IP Address Group Overview
Updated on 2024-11-05 GMT+08:00
An IP address group is a collection of IP addresses. You can use IP address groups to manage IP addresses with the same security requirements or whose security requirements change frequently.
You can configure a whitelist or blacklist to allow or deny accesses from IP addresses in an IP address group to listeners.
You can add IPv4 or IPv6 CIDR blocks to an IP address group and associate the IP address group with a maximum of 10 listeners.
Parent topic: IP Address Groups
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.
The system is busy. Please try again later.
