Modifying a Static Route
Scenarios
This section describes how to modify static routes, including common routes and blackhole routes, in a route table of an enterprise router. For example, you can perform the following operations:
- Change a common route to a blackhole route.
- Change the attachment type and next hop of a common route.
Only static routes can be modified. Propagation routes cannot be modified.
Notes and Constraints
To change the destination of a static route, delete this static route and create another one with your desired destination.
Procedure
- Log in to the management console.
- Click
in the upper left corner and select the desired region and project.
- Click Service List and choose Networking > Enterprise Router.
The Enterprise Router homepage is displayed.
- Search for the target enterprise router by name.
Figure 1 Searching for an enterprise router
- Go to the Route Tables tab using either of the following methods:
- In the upper right corner of the enterprise router, click Manage Route Table.
- Click the enterprise router name and click Route Tables.
Figure 2 Modifying a static route - Click the route table where you want to modify a route. On the Routes tab, locate the route and click Modify in the Operation column.
The Modify Route dialog box is displayed.
- Modify the route based on Table 1.
Table 1 Parameter description Parameter
Setting
Example Value
Blackhole Route
Optional
If Blackhole Route is enabled, you do not need to configure Attachment Type and Next Hop for the route. If the destination of a route is the same as, or is contained in, that of this blackhole route, all packets destined for the destination will be dropped.
-
Attachment Type
- If Blackhole Route is not enabled, you need to configure this parameter.
- If Blackhole Route is enabled, you do not need to configure this parameter.
VPC: You want to attach a VPC to an enterprise router.
For more information, see Attachment Overview.
VPC
Next Hop
- If Blackhole Route is not enabled, you need to configure this parameter.
- If Blackhole Route is enabled, you do not need to configure this parameter.
Select the attachment from the drop-down list.
er-attach-01
- Click OK.
View the modified static route in the route list.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.