Filtering Resources

Scenario

This section describes how to filter resources on the Resource List page of the Config console. This helps you track resource details, including regions and states.

To use the resource list, you must enable the resource recorder. If a resource is missing from the list, verify if the resource recorder is enabled, if the resource type is within the configured monitoring scope, or if the service or resource is supported by Config.

There is a delay in synchronizing data to Config, so if there is a resource change, the change may not be updated in the resource list immediately. If the resource recorder is enabled, Config synchronizes and corrects resource data within 24 hours.

Procedure

1. Log in to the Config console.
2. On the Resource List page, the resources you own within the monitoring scope of the resource recorder are displayed by default.

   

3. Select a service, resource type, and region to search for resources. For global services, you do not need to set the region.

   

4. Use the search box in the middle of the page to apply refined filters.

   

   Filter	Description
   Name	Resource name. Fuzzy search is supported. The resource name is case-insensitive.
   Resource ID	Resource ID. Fuzzy search is supported. The resource ID is case-sensitive.
   Tag	Resource tag. You can select a tag key and one or all values of this key to filter resources.
   Enterprise project	The enterprise project which resources belong to. If you select an enterprise project, resources in this enterprise project will be displayed. NOTE: To filter resources by enterprise project, you must first enable Enterprise Project.

Related Information

The resource list allows you to perform the following operations on your resources:

• Querying Details About a Resource
• Exporting Resource Information
• "Viewing Resource Compliance Data" in the Config User Guide
• Viewing Resource Relationships
• "Viewing Resource Changes" in the Config User Guide