Step 5: Add a Route

Scenarios

After the private NAT gateway is configured, add a route in the route table of the service VPC to point to the private NAT gateway.

Procedure

1. Log in to the management console.
2. Click in the upper left corner and select the desired region and project.
3. Click Service List in the upper left corner. Under Networking, select Virtual Private Cloud.
4. In the navigation pane on the left, choose Route Tables.
5. In the route table list, click the name of the route table associated the service VPC.
6. Click Add Route and configure required parameters.

   Table 1 Parameter descriptions

   Parameter	Description
   Destination	The destination CIDR block Set it to the CIDR block used by your on-premises data center.
   Next Hop Type	Set it to NAT gateway.
   Next Hop	Set Next Hop to the private NAT gateway.
   Description	(Optional) Supplementary information about the route Enter up to 255 characters. Angle brackets (< or >) are not allowed.

7. Click OK.