CentOS 6/RedHat 6

Updated on 2022-09-09 GMT+08:00

View PDF

NOTE:

For CentOS 6 and Red Hat 6, you need to install cloud-init, cloud-utils-growpart, and dracut-modules-growroot. Cloud-Init has been installed in Installing Cloud-Init.

This section uses CentOS 6.9 as an example to describe how to install them.

Check whether cloud-init, cloud-utils-growpart, and dracut-modules-growroot have been installed. If no, perform the following steps to install them.

[root@localhost ~]# rpm -qa | grep cloud-init
cloud-init-0.7.5-10.el6.centos.2.x86_64
[root@localhost ~]# rpm -qa | grep growpart
[root@localhost ~]# rpm -qa | grep growroot
[root@localhost ~]#

Download cloud-utils-growpart-0.27-10.el6.x86_64.rpm and upload it to the VM as instructed in Upload Required Software Packages.
You can download the package from:

https://dl.fedoraproject.org/pub/epel/

Run the following command to install cloud-utils-growpart:

rpm -ivh cloud-utils-growpart-0.27-10.el6.x86_64.rpm

[root@localhost redhat]# rpm -ivh cloud-utils-growpart-0.27-10.el6.x86_64.rpm
Preparing...                 ############################### [100%]
   1:cloud-utils-growpart    ############################### [100%]
[root@localhost redhat]#

Install dracut-modules-growroot.
1. Run the following command:
  yum install -y https://archives.fedoraproject.org/pub/archive/epel/6/x86_64/epel-release-6-8.noarch.rpm
2. Run the yum install dracut-modules-growroot command to install dracut-modules-growroot online.
  Enter y when the message Is this ok [y/N] is displayed.
3. Run the dracut -f command to update the kernel.
Run the commands in 1 again to check whether cloud-init, cloud-utils-growpart and dracut-modules-growroot are successfully installed.