Global Accelerator
Global Accelerator
- What's New
- Service Overview
- Getting Started
- User Guide
-
FAQs
- Can I Use the Ping Command to Test Latency?
- How Will I Be Billed for Global Accelerator?
- How Can I Increase the Global Accelerator Quotas?
- How Can I Use Traffic Dial to Distribute Traffic?
- What Types of Endpoints Can Be Added to a Global Accelerator?
- Can I Use Global Accelerator in an Area That Is Not Listed Among the Acceleration Areas?
- What Are the Statuses and Health Check Results of Endpoints?
- What Should I Do If an Endpoint Is Unhealthy?
- Most Frequently Asked Questions
- Configuring the TOA Module
- How Can I Use Global Accelerator to Enable European Users to Access the Applications Deployed in or Outside the Chinese Mainland (Excluding Europe) Faster?
On this page
Show all
Help Center/
Global Accelerator/
FAQs/
What Types of Endpoints Can Be Added to a Global Accelerator?
What Types of Endpoints Can Be Added to a Global Accelerator?
Updated on 2025-02-28 GMT+08:00
An endpoint is where requests are routed to. You can add an EIP as an endpoint.
If there are multiple endpoints in an endpoint group, you can set a weight for each endpoint to specify the proportion of requests to distribute to each endpoint. The global accelerator adds up the weights of all endpoints in the endpoint group and routes requests to each endpoint based on the ratio of its weight to the total weights.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.
The system is busy. Please try again later.
