Help Center/
Application Service Mesh/
FAQs/
Adding a Service/
Why Cannot I Select the Corresponding Service When Adding a Route?
Updated on 2023-07-03 GMT+08:00
Why Cannot I Select the Corresponding Service When Adding a Route?
During adding a route, the target service is filtered based on the corresponding gateway protocol. The filtering rules are as follows:
- For an HTTP gateway, select an HTTP service.
- For a TCP gateway, select a TCP service.
- For a gRPC gateway, select a gRPC service.
- For an HTTPS gateway, select either an HTTP or a gRPC service.
- For a TLS gateway which TLS termination is enabled, select a TCP service. If TLS termination for a TLS gateway is disabled, select a TLS service.
Parent topic: Adding a Service
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.
The system is busy. Please try again later.
