Deze pagina is nog niet beschikbaar in uw eigen taal. We werken er hard aan om meer taalversies toe te voegen. Bedankt voor uw steun.
Application Service Mesh
Application Service Mesh
- What's New
- Service Overview
- Getting Started
- User Guide
- Best Practices
-
FAQs
- Service Mesh Cluster
- Mesh Management
-
Adding a Service
- What Do I Do If an Added Gateway Does Not Take Effect?
- Why Does It Take a Long Time to Start the Demo Application in Experiencing Service Mesh in One Click?
- Why Can't I Access the page of the Demo Application After It Is Successfully Deployed?
- Why Cannot I Select the Corresponding Service When Adding a Route?
- Performing Grayscale Release
- Videos
On this page
Show all
Help Center/
Application Service Mesh/
FAQs/
Performing Grayscale Release/
Why Can't I Change the Image Used for the Grayscale Version When Performing Grayscale Release?
Why Can't I Change the Image Used for the Grayscale Version When Performing Grayscale Release?
Updated on 2023-07-03 GMT+08:00
Description
When I perform grayscale release, the image used for the grayscale version cannot be changed.
Analysis
When performing grayscale release on a service, you create a new version of the same service. Therefore, the image used by the service cannot be changed. Only image tags can be changed.
Solution
Pack the required image into a different tag of the same image and push it to the image repository. Then, select the newly pushed image tag when you perform grayscale release on the service.
Parent topic: Performing Grayscale Release
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.
The system is busy. Please try again later.
